Gary Jackson: Fire When Ready Pottery
A Chicago potter’s somewhat slanted view of clay & play
Categories: mugs, process, production

After the workshop, I was back in the studio to turn my stamped cylinders into mugs.
So I started by wedging up some reclaim clay. It’s the same clay body as the thrown cylinders, but I needed to dry it out a bit as it was still too squishy. So I wedged it and then flattened out pieces as slabs so the moisture would soak into my canvas-covered table faster… and then wedged it back up again. I then cut it up into 36 nuggets of clay… one for each of the cylinders. It’s going to be a LONG afternoon!

Then I take each “nugget” and slam it against the table, throwing it a bit away from me so it compresses and elongates at the same time. I rotate the nugget in between each toss. After a few times, you start to get this “carrot” shaped piece of clay.

Then I pull my handles the old-fashioned way. Holding the thicker part of the “carrot” at the top, wetting my hand and sliding it down with a bit of friction. It’s that repeated swipe of friction that starts to lengthen the clay and make it into a strappy handle.Once I get it to the width & thickness I like, I do a quick flick, loop and squish to get them to stand up like this. I like how it establishes the curve of the handle right at the start. Easier than trying to manipulate a straight strap into a curve later.

I let them set-up for about 15-20 minutes. I want them to be malleable, but not sticky or squishy. Then I set in to attaching them. I do a bit of scoring on the cylinder, and then cut off the “good” portion of the handle that I want to use. I score the end of the handle and add some slip. Carefully squishing them together and smoothing out the attachment. I always do the top attachment first, but then do the same for the bottom once I’ve established the right size for the handle.

One the handle is attached both top & bottom, it’s on to the task of smoothing it all together. Trying to make it look nice and smooth, like the handle has grown out of the mug and is actually part of the mug… not just a squished on attachment.

Score. Slip. Repeat…  Score. Slip. Repeat…   Score. Slip. Repeat…  33 more times!

And now all 36 mugs are back under wraps for the night.
Tomorrow night I plan to add some accents with colored flashing slips.

Save

Save

Save

Save

Save

Save

Leave a Comment